Log In - Register
Worldwide Distributor of Aircraft Parts and Pilot Supplies
   
Order Status Page Check Out Page Order Form Page Home Page Shipping Page Contact Us Page Help Page
1-877-477-7823  Airframe Parts - Firewalls

STAINLESS STEEL
FIREWALL SHIELDS

Two piece shields for use over cables or wires with large end-fittings or existing installations. Single piece for use where the cable or wire may pass through the hole. Flat shields designed for use on wooden or composite firewalls using a fire resistant sealant to prevent leaks. Both types of shield available in flat or with dimple to accommodate rubber grommets up to outside diameter. Actual hole size in 2 piece shields is slightly larger than indicated to prevent chafing cable. Ream pilot hole in single piece shields oversize for the size grommet used. Use grommets that fit tightly around the cable or wire to insure a good seal. Shields may be installed with screws, bolts and plate nuts or rivnuts. Install cable and grommet in firewall. Locate the shield to insure that it is centered on the cable - then drill attach holes in firewall. Shields predrilled with 5/32" mounting holes. If more than one cable passes through grommet fire resistant sealant must be applied to grommet.

CAUTION: Any holes drilled in the firewall are potential source of carbon monoxide in the cockpit. Extreme caution must be exercised when installing firewall shields in your aircraft. They do not provide the necessary seal around cables or wires to prevent carbon monoxide, smoke or fire from entering the cockpit. The shields are designed only to protect the sealing material (grommets/gaskets) from excessive heat.
Click to Enlarge
Single Piece 3/16" Hole with Rubber Backing
Part No. 61-175 $7.80 ($8.50CAN)

Single Piece 5/16" Hole 3/4" Dimple For Grommet
Part No. 61-225 $7.80 ($8.50CAN)

Two Piece 3/8" Hole 1" Dimple For Grommet
Part No. 61-375 $10.80 ($11.77CAN)

Two Piece 3/8" Hole 1-1/4" Dimple For Grommet
Part No. 61-475 $9.70 ($10.57CAN)

Two Piece 1/2" Hole 3/4" Dimple For Grommet
Part No. 61-300 $9.70 ($10.57CAN)

Two Piece 1/4" Hole 3/4" Dimple For Grommet
Part No. 61-250 $9.70 ($10.57CAN)

Two Piece 3/8" Hole 3/4" Dimple For Grommet
Part No. 61-275 $9.70 ($10.57CAN)

 



Order StatusCart/Checkout Search HomeHelpContact Us
ACS Specials/New ProductsShopping ListsPrice MatchSitemap

Exchange rates as of Nov 13, 2009 are estimates only. Invoice will be in US Dollars.

Copyright © 1995 - 2009 Aircraft Spruce and Specialty Co. All rights reserved. Prices shown are in USD.
Prices, features, and specifications are subject to change without notice.
Images are for reference only and actual product appearance may vary.