Click Bond Fasteners mount to surfaces
with adhesive. They are assembled in a disposable, self-fixturing
device of plastic that aligns and holds the fastener in position
and under controlled pressure while the bonding material cures.
After the installation is completed, the holding fixture is removed
and the conventional attachment is made to the fastener. Bonded
fasteners eliminate welding or drilling surfaces and result in
reinforced substrate strength, leakproof and corrosion resistant
attachments. Aircraft Spruce & Specialty Co. offers Click
Bond Fasteners in convenient, pre-packaged kits as shown.
CABLE TIE MOUNT KIT
P/N 04 06000
Each cable tie mount in this
kit is pre-assembled in a temporary, easy-to-remove fixture that
holds the cable tie mount in place and under pressure while the
adhesive cures. No additional installation tools are needed.
The kit includes four CB3019AA3N cable tie mounts with nylon
ties (5" 40 lbs.), one adhesive packet, surface preparation
materials, and installations.
FLOATING NUTPLATE KIT
P/N 04 06005
The Click Bond adhesive bonded
floating nutplate has a metal base and is installed using a disposable,
elastomeric fixture that temporarily holds the nutplate in place
and under pressure while the adhesive cures. The fixture prevents
fouling of the clearance hole. No additional tools are needed
for making the nutplate attachment. This fastener meets or exceeds
the standards set by MIL-N-25027 for push-out, torque-out, and
cycle life.
Bonded nutplates eliminate
composite damaging rivets, reinforce the structure, and reduce
installation time. The kit includes four CB2009A3S floating nutplates
(10-32) with aluminum baseplate, one adhesive packet, surface
preparation materials, & instructions.
REPAIR PATCH KIT
P/N 04 06015
These self-fixturing
surface mounted patches repair small holes & fastener leaks
without access to the reverse side of the surface. Patch is adhesively
bonded to flat or curved surfaces with aid of an integral, disposable
fixture. High peel strength adhesive allows patches to withstand
super- sonic flight, cleaning, de-icing, & paint stripping.
Patches can be removed easily with heat application. Kit includes
1 CP125-000-005A1A1 aluminum repair patch (.005 thk. & 1.25"
dia.), 1 adhesive packet, surface prep matl, & instr.
CB 200 ACRYLIC ADHESIVE
P/N 04 06040
A high strength, two part adhesive. 3.5
gram package. One package is usually sufficient to do five of
any Click Bond fasteners.
STUD KITS
Click Bond studs are available
in several sizes. The Metal Small Base Stud Kit includes (6)
CS62-1032-12AX-CR aluminum small base stainless studs, (6) stainless
nylocks/washers (10-32), 1 adhesive packet, surface preparation
materials, and instructions. The Metal Large Base Stud Kit includes
4 CS125-1420-16AX-CR aluminum large base stainless studs, 4 stainless
nylock/washers (1/4-20), 1 adhesive packet, surface preparation
materials,
and instructions. The Fiberglass Base Stud Kit includes 2 CS125-1032-12G-CR
fiberglass large base stainless studs, 2 stainless nylocks/washers
(10-32), one adhesive packet, surface preparation materials,
and instructions.
