Complete kit 4.25 gallons for RV-6-7-9 "hidden" tank with flop tube. Custom made to fit flush behind the pilot or passenger seat back. Uses no baggage space and is nearly invisible to admirers of your plane.
Kit is also available with a 7 gallon oil tank. Typical install time is 1 full day. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
5 stars is too modest, and when they say “complete”, they mean it. I spent less than $1 on additional parts to complete the install, and they even threw in some useful swag! The ONLY slight critique I have would be that the fittings for the flow rate metering valve are awkward, it’d be much better if it could be mated directly to the pump instead of floating with a length of tube. Other than that tiny gripe, a very quality and very complete kit. And at much less $$ than comparable kits that only give you one injector! 10/10, and I’ll be ordering a few more for my other aircraft as well.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The entire installed system, hoses, hardware, tank, pump, etc. will weigh 12 pounds. The same as 2 gallons of gas. For most small engines of 200 hp or less the oil flow is .5 gal per minute so the 3 gal tank should last 6 minutes if you run it continuous. Normally we fun flyers only have it turned on for 15 to 30 seconds at a time so it lasts a long time.