The RAM-B-121-AP8U consists of a yoke clamp base , double socket arm and non-locking cradle for the Apple iPad 1, 2 , and 3. The RAM yoke clamp mount for the Apple iPad and iPad 2 will fit rails from 0.625" to a maximum of 1.25".
Designed into the mount is a 1" diameter patented rubber ball and socket system with adjustment points at the base and cradle. With a twist of the arm knob, you can move the iPad flat surface mount to your optimum viewing position.
This will fit the iPad 1, 2, 3, and 4 (the package comes with two stick on bummers for the 2, 3 and 4). You can have a screen protector but the RAM will fit the Ipad only no case.
No, for the iPad Pro 9.7, you would need 1 each of the following part numbers for the same set up for your device: 11-12358, 11-07069, 11-01255, and 11-12930.
No, the cradle in this kit is fixed height and width and will only fit specific iPads listed.
There is no specific aircraft application guide. As long as the yoke int he 737 has a rail from 0.625" to a maximum of 1.25" it will work great.
No, this is designed to work with the first gen ipads. For the iPad Pro 10.5, you will need the following part #'s for the iPad Pro 10.5. 1 x 11-15889, 1 x 11-07069, 1 x 11-01255, 1 x 11-12930. This system will not work with a protective case or sleeve.
If by iPad 5 you mean the iPad Pro 9.7, then this will not work. For that iPad, you would need the following part #'s to have a yoke mount system: 1 x 11-12358,1 x 11-07069, 1 x 11-01255, 1 x 11-12930
11-08577, 11-07069, 11-01255, and 11-12930
No, for the iPad Pro 10.5 inch, please order part #s: 11-15889 + 11-07069 + 11-01255 + 11-12930.
No, this works with the original iPad sizes. For the iPad fifth gen, you would need the iPad Air cradle. Use the following part #'s to have a yoke mount system: 1 x 11-12358,1 x 11-07069, 1 x 11-01255, 1 x 11-12930
Order 1 each of the following part #s for the iPad 6th gen to yoke mount system: 11-12358, 11-07069, 11-01255, & 11-12930.