|LED panel mount, Snapfit, Low Profile red Indicator Light with diffused lens. These are constructed with a low profile black nylon housing with integral bezel. It is supplied with two color-coded 6-inch wire leads. It is available in 12VDC or 24VDC. Indicators Snapfit into 6.35mm diameter mounting hole with a recommended panel thickness range of 2.90 to 3.30mm thick. It has current of 20mA typical.|
This LED works great in my homebuilt plane. I use it for the status monitoring line on my IBBS battery as well as my EarthX lithium battery. Simply drill a 1/4 hole in the panel, and press this LED into the hole. Nice snug fit and wont fall out or rattle loose.
Good product works as intended, expensive compared to Incandescent lamps but should be used in areas where you do not wish to change the bulb (i.e. Custom Trim UP/Down indicator applications in Experimental / Homebuilt aircraft.
Per the supplier: No, this does NOT require a resistor.
The bulb size is 5.08 mm.
No, the 11-07839 led indicator is not a Push-to-Test light. A specification sheet has been added under the Documents tab.
It is best to use a rheostat designed for LED products. Standard rheostats do not work well.