Dimensions: 1.73 in x 0.60 in (4.4 cm x 1.5 cm)
Weight: 0.32 oz (9 g)
Turn on first: Constant lighting / Turn on second time <3s: Fast Strobe. Switch between modes in fog/cloud etc
NavStrobe Wingtip Bulbs: Will replace the following commonly installed bulbs: W1290-14, W1290-28, T7572-12V, T7572-24V, or any BAY15S base lamp. See "Dimensional Drawing" tab to confirm dimensions will work with currently installed bulb on your aircraft.
1- Too short for my plane.
2- When I turn them on, one flashes and the other one does not. NOT ACCEPTABLE. Anyway, nav. lights should NEVER flash.
September 29, 2018
Look very cool, much cheaper than the side reflector bulbs for wing tips, quite bright.
Cause RF interference in all modes (strobe or steady).
They are a tad short for my wingtip lights. Should have bought the 3 led row model, not this 2 row one, but that is my fault for being over-cautious on whether they would fit!
December 21, 2016
Bad RF interference. Will have to remove and try something different.
December 9, 2019
Q: How do you switch between steady and flash mode? Do these just plug in to existing sockets?
You got it. They install in to the current socket, and when turned on they stay constant on, then if the navlight switch is turned off and on again, the bulbs will strobe.
Q: Will the Aircraft LED wingtip Nav light fit as replacement bulbs in a set of Aeroflash nav/strobe combo units on a Cessna 172?
The Aircraft LED wingtip Nav Lights are for Experimental aircraft use only. They are not FAA/PMA approved.