EVERYTHING FOR AIRPLANES SINCE 1965 | 877-4-SPRUCE

JPI EDM Manifold Pressure Sensor 0-60

$269.00/Each
Quantity
Add to Wishlist
Part# 11-03348
MFR Model# 604010

Overview

For manifold pressure monitoring
0 - 60 inches of Hg. 1/8NPT
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

This JPI MAP sensor replaced the original JPI sensor that was installed with my JPI-830 from 13 yrs ago. If this replacement lasts as long as the original, Id be grateful. It came with the T-fitting, but I only needed the sensor. The new sensor threaded right into the original T-fitting upon engine start, JPI MAP readings came to life and the readings matched the original steam gauge still installed in the panel.

Aircraft R Verified Purchase

JPI EDM MANIFOLD PRESS SENSOR 0-60IN 1/8 NPT 604010 TSO

November 16, 2023

When a prior unit failed within 30 days, Aircraft Spruce worked with JPI to get a replacement under warranty. Their service was exceptional.

Jim J
April 13, 2020

Came without the plug for the sensor. Catalog should specify the part number(s) without and with the plug. I’ve been waiting over a week for the plug direct from JPI now.... not a normally stocked plug at our avionics shop

Jim
December 11, 2020

Doesn’t come with a plug for the sensor itself. Had to call JPI direst for a plug

Jim
December 6, 2020

Solved the problem. JPI provided test procedures to verify failure of old unit. Cost is outrageous compared to intrinsic appearance of a small molded piece of black plastic, but cheaper than buying direct from JPI.

Dick K
October 25, 2020

Very poorly designed. For the cost of this thing, it is very fragile. The pins inside of it will bend if you are not very careful plugging the cable in. If that happens, you will need to replace the unit. It is not repairable.

James
April 16, 2023

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Are there any harnesses for this sensor? What type of electric socket is used in this sensor?

This is the replacement sensor part for the JPI MAP (using the JPI MAP harness you already have. If you want the complete MAP you will need to order 10-04512.

Q: Can I put this sensor in the JPI EDM 900?

No, the part # 11-03348 only works with 730/800/30. Part # 10-06238 is the correct part for the JPI EDM 900.