|Matco Solid Rubber Tire Tailwheel Assy.||06-01615||$189.75|
|Replacement Tire (Solid Rubber) for T-6||06-00004||$97.75|
|Matco 6" Pnuematic Tailwheel Assy.||06-00831||$224.95|
|Matco 6" Pneumatic Tire & Tube||06-00832||$24.70|
| Matco 7" Pneumatic Tire Tailwheel Assy.
Overall length of 10.50" and max width of this tail wheel with fully splayed arms is 9.29" and overall height is 10.2"
|Matco 8" Full Swiveling Pneumatic Tire Tailwheel Assy.||06-01620||$267.95|
| Matco 8" Pneumatic Wide Tailwheel Assy.
Overall length of 12.51". Max fully splayed arms is 9.29" and overall height is 15.7". Weight 8lbs
|McCreary Replacement 8" Tire 2.80/2.50-4 4PLY||06-08000||$52.75|
|McCreary Replacement Tube 8" 280 x 250 x 4||06-08101||$23.85|
|Matco tailwheels use a fiberglass reinforced nylon wheel with an operating load of 450 lbs. It takes over 5000 lbs to fail the wheel and it will hold up in the most rigorous conditions. Can be used with 1-1/4" or 1-1/2" leaf spring. These tailwheels are steerable, and are available with a 6 inch hard rubber solid tire or with 8" Shin pneumatic tire and tube for heavier aircraft. Tailwheel construction is anodized aluminum. Weight: 5 lbs. NOTE: The 7" tire comes in gray.|
I like the idea of a phonematic wheel for my tailwheel. I wanted one as small as I could get. A/S filled that order. The detent is a little stiff but I am sure it will work out just fine. The next item I want is a spare tube or two for this wheel.
Well finished tailwheel assembly. Works fine. Fit nicely in my Thatcher CX4
I have a Longez and bought this tire to go on a Grove 4 front leg tire. The tire comes with a saw tooth pattern which could potentially pick up small stones from the runway and flick them back into the propeller. The tire is tough, well made (in China) and would suit a tail wheel application but I wreally wanted a slick or a straight groove tire that will fit up into my Longez nosewheel bay. Can anyone assist???
The McCreary replacement tube (p/n 06-08101) received was a Firestone Made in China. The valve stem on this tube is supposed to be bent 90 degrees. All of the three tubes I got had stems bent about 45 degrees and do not fit a tailwheel hub. Customer service did credit my account but I must find another source for this tube and so does Aircraft Spruce.
The wheel is a two piece wheel and does not require any special tool for mounting the tire. You would split the rim in two pieces by disassembling the "insert" into the tire. The wheel tie bolts are AN-3 bolts so 3/8" hex heads.
This wheel incorporates a geometric release mechanism that allows the wheel to caster after reaching a |steered angle of 40 degrees. This allows the tail wheel assembly to be steerable and full swiveling and provides easy installation with variant spring tension.
Yes, the solid tire and wheel assembly can replace the pneumatic tire and wheel assembly.
Per the assembly drawing provided under the overview description, it uses a 2.80/2.50-4 tire, so the 06-08000 tire and 06-08101 tube would fit this unit.