|5-Inch Skull Spinner Assembly Polished with mounting bracket & hardware||Wood or Metal Props on Continental A-65 to O-200 engines||10210||$59.95|
|6-Inch Skull Spinner Assembly Polished with mounting bracket & hardware||Lycoming O-235 to O-360 engines and Cessna 170s||10220||$66.50|
|5-Inch Skull Spinner Dome||Wood or Metal Props on Continental A-65 to O-200 engines||05-21600||$44.50|
|6-Inch Skull Spinner Dome||Lycoming O-235 to O-360 engines and Cessna 170s||05-21700||$52.75|
| Skull Spinner Dome
Mounting Bracket & Hardware
|For both 5-Inch & 6-Inch Skull Spinner Dome||05-21800||$13.75|
Skull Spinner Assemblies & Skull Spinner Domes for your A-65 to O-200 Continental or O-235 to O-360 Lycoming engines.
5-inch diameter - For wood or metal props on Continental A-65 to O-200 engines. High-polish finish & top quality.
6-inch diameter - For Lycoming O-235 to O-360 engines.
Made in USA
Not FAA Approved.
Old bracket broke, this replacement piece is very heavy duty & the skullcap fit perfect on the prop hub. Will see how it does after a few hours of flying but dont anticipate any problems.
This bracket and polished cap are far superior in quality to original. I recommend anyone flying with the original bracket upgrade to this much thicker/stronger version. I had an original bracket fail in flight and its not a fun experience. The only improvement I would make is to use a larger machine screw since the one supplied did not stay tight on the cap.
Well made, not cheap in any way. Perfect fit. I would recommend this to anyone.
The screw in the center consistently comes loose. The material is very soft and concaves against the propellor. The entire dome came off in flight damaging my propellor. I had suspected it to be the screw holding it to the bracket but it was actually the bracket that sheared off right at the bolts.