EVERYTHING FOR AIRPLANES SINCE 1965 | 877-4-SPRUCE

Skull Cap Spinner Assembly (Small)

$116.75/Each
Quantity
Add to Wishlist
Part# 05-06844
MFR Model# SM-SPIN-ASY

Overview

Skull Cap Spinner Assembly (small) for Cessna, FAA/PMA approved.
For wood or metal propellers on Cessna C-120, C-140, and C-140a
Note: The spinner dome and the spinner bracket are included with assembly.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Good quality spinner and bracket. I especially like the thin bracket that acts as a spring and holds the spinner tight. Ive been through several of the other kind with a stiff, rigid bracket. They are always a problem. The last one even cracked off and the bracket scraped up the full length of my prop as it departed. Not this one. It has a well designed bracket that tightens down and holds tension when you tighten the screw. No more loose screws, cracked screw holes, loctite, spinner wear on the prop hub, spinners flying off, broken brackets, nicked and scraped propellers, all things of my past. Its almost like the manufacturers knew what they were doing when they made this bracket flexible and springy, and got PMA approval.

Low C Verified Purchase

SMALL SKULL CAP ASSEMBLY SPINR

April 16, 2023

Considering that the alternative is close to $2K, this is a great solution. The mounting bracket could stand to be a bit thicker as it does twist under the 30Ft/lb of torque required of the prop bolts. A box wrench will hold the counter force needed to make it work tho. A little polish and paint before assembly and she lools great!

Kory N Verified Purchase

SMALL SKULL CAP ASSEMBLY SPINR

March 7, 2023

For a more more aesthetic part it would be nice if it had less scratch marks in the aluminium.

Gabe
October 14, 2020

Mount bracket is so thin that it twisted and deformed when the prop bolts were torqued to specification. Terrible engineering done on this mount bracket, and its FAA/PMA. Really?? Found a used older bracket that was twice as thick to use. Stamped UNIVAIR all over it. Dont waste your time or money. Spinner is fine, no problems there.

Julians A
May 2, 2022

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Can these be polished to a chrome like finish?

Yes, they can be.

Q: Is this a 5 inch or 6 inch skull cap?

Dome diameter: 5.125 inches outside diameter

Q: Is this the same as 0450510-1 and 0450260?

No this kit is made up of spinner dome (U0450279) and bracket (U0450281).

Q: What paperwork comes with this spinner?

There is no paperwork included in the box, however, they are stamped as FAA PMA.

View in Catalog

View Image View in Catalog