This wing tip, 100% LED, strobe and navigation light system features a cluster of very bright LEDs and using a common controller that furnishes the heads with a junction point for synchronizing and selecting one of the 7 flash patterns of the LED STROBES. It also allows for a separate power source to the navigation red, green and white LEDs.
The system includes 2 heads (one left & one right), mounting adapter plates for mounting on a radius, 50 feet of 3 conductor wire, plugs, pins, 1 controller, misc. wire connectors and mounting hardware.
Made in USA
Navigation Colors: Aviation Red / Green forward and White aft
Strobe: Synchronized with seven (7) selectable flash patterns
Weight: 2 heads and controller / 12 ounces
Power draw: Strobe and Position lights are LESS than 2 Amps at 12 to 14 volts
Footprint Dimensions (Heads): 3.2" long x 1.1" wide
Outstanding unit especially for ELSA application. Easy install and works well. Great substitute from incandescent strobes and position lights.
February 11, 2019
Q: Are these approved for certified aircraft?
No, they are not approved for certified aircraft.
Q: Is the dimensions units is cm or inch? Footprint Dimensions (Heads): 3.2 long x 1.1 wide / Footprint Dimensions (Controller): 2.2 x 5
These dimensions are listed in inches.
Q: You state that the current draw for the lights is less than 2 amps do you mean that: <br>
Both lights together are less than 2 amps, or each light is less than 2 amps?
Does the amp figure consider when both the strobe and nav light is flashing?
Yes, the 2 amp rating is for the entire system. This takes into account both the strobe and nav lights.
Q: What is the lens made out of on the Kuntzleman LED aircraft lighting system? Is it glass or polycarbonate?
This lens is polycarbonate.
Q: What is the acceptable input voltage range for this system?
This unit requires 12/14 volt aircraft power to the power supply.
Q: Are these approved for night flight in an experimental aircraft?