|A quality gauge which is complete with all installation fittings. Range is 100-250° F. 5/8"-18 female capillary adapter fitting. 60" lead length. Not FAA Approved.|
Good quality and accurate. Works great. It took a bit of turning to get the probe through the large screw part, but it did fit.
very nice well built gauge, with all the correct fittings. i only needed a 3 ft capillary line instead of 5 ft. and it could use some type of lock washers or lock nuts to hold the clamp to the gauge instead of plain. highly recommend.
Gauge is fine. Temp bulb fits too tightly into engine adaptor. Excess soldier on temp bulb had to be removed with emery cloth. Also, protective brass sleeve was not crimped adequately.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
It will fit in a 2-1/16" to 2-1/8" panel hole.
Approx 75 inches.