Thumbs 1
Thumbs 1
Thumbs 1


Part# 05-06236-2
MFR Model# H-858-001


TSO'd Seat Belts & FAA Approved "Y" Harness Combination. Set includes one Cat. No. H-701 series seat belt with 3 bar slide and one Cat. No. H-702 series "Y" type shoulder harness with metal to metal hardware.
California Prop 65 Warning Symbol

WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm.


Very nice quality. Lap belt did not work for my application unfortunately (wide rear seat citabria) - too short on the length. Came with 3 bar slides and instructions to reuse existing OEM hardware. Nice setup, wish the seat belt was longer for a more universal fit! Double adjustment would be nice on the lap belt as well.

Washington P Verified Purchase


June 14, 2022

Worked perfectly in my 47 bonanza!

Brian B
March 23, 2020

Perfect seatbelt and shoulder harness for my 47 Navion application. Good quality and price.

Jim J
April 1, 2017

Very good

Morten M Verified Purchase


March 4, 2022

Worked well in my 1947 taylorcraft

Tom G
February 28, 2019


Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: How does the end of the Y harness bolt into the airplane?

Depending on the aircraft there are different ways this can be installed. One way, if you have a head bar, you can mount this around a tube above the head bar. Another way is you can drill a hole in the spar and use a triangular fitting (does not come with harness) along with lubing a 3 bar slide (comes with harness) and put everything together. With each aircraft it may be different, so different hardware may need to be purchased depending on the application.

Q: Where do I find the mounting hardware?

Per the manufacturer: You would use the existing hardware that was on your origional seat belt harness.

Q: Regarding part# 05-06236-4: Do you know if this works for a 1963 C182F?

These harnesses are FAA TSO Approved but not STC'd for specific aircraft types. You will need to verify with your A&P that these can be installed in your model/make.

Q: Does the lap belt tighten from both sides?

These belts only adjust at the buckle on one side only.

Q: Does the lap belt have the TSO label on the belt? I have TSO belts but the labels came off.

These belts are tagged with FAA-PMA on the label.

Q: What is the length of the webbing for the belt and harness in this combo?

The longest length on the shoulder harness is 79 and the longest length on the seat belt is 62.

Q: Does these harnesses come with just one 3-bar-slide, or a total of three?

The harness comes with 1 3 bar slide and the belts come with 2 3 bar slides.

Q: What is the width of the belt? 3?

The width of these belts is 2".

Q: I am looking for the belt only (lap part) that come with the harness kit. What is the part # for the belt only?

Our part # 05-06225-2 is the black version.

View in Catalog

View Image View in Catalog