Description | PN |
---|---|
B&C BC410-H Alternator Sd 40Amp Homebuilt | 07-06771 |
BC410-H Alternator
The BC410-H is a high-performance spline-driven alternator that mounts on a standard vacuum pump accessory pad (AND20000). It may be used either as a primary or a stand-by alternator for a rated output of 20 – 40 amps @ cruise RPM. Constructed of all NEW materials (with absolutely NO remanufactured content), the BC410-H is designed for durable service, with heavy-duty sealed ball-bearings, two cooling fans, a dynamically balanced rotor, and a special shear section designed into the drive coupling. Measuring 4.6″ wide and 6″ deep, and weighing only 5.75 lbs., the BC410-H will clear the tachometer cable and oil filter on stock Lycoming engines.
The BC410-H is available for both 14 volt and 28 volt applications, and is externally-regulated. It should be appropriately matched with our LR3D, LS1B, or SB1B Controllers (depending on your application and electrical system configuration). NOTE: L-40, BC460-H, BC410-H, and BC462-H alternators require external regulators - use: P/N 07-06742 (LR3C) for 14V Primary, P/N 07-06786 (LS-1A) for 28V Primary, P/N 07-03461 (SB1B-14) for 14V Standby, and P/N 07-03462 (SB1B-28) for 28V Standby. |
![]() |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Nice unit. Looking forward to installing and test.
B&C BC410-H Alternator Sd 40Amp Homebuilt
B&C BC410-H Alternator Sd 40Amp Homebuilt
Its an alternator and it works not much more to say time will tell
B&C BC410-H Alternator Sd 40Amp Homebuilt
Perfect replacement for an older SD20 that was installed in the aircraft. The alternator actually has higher output at a lower RPM than the one it replaced.
Well built Alternator that actually fits on the vacuum pump drive mount on Lycoming IO390. I bought the slightly larger model BC462-H but it did not fit, it interfered with standard oil filter although it also said it would fit on that same accessory pad. Turns out it only fits if the optional 90 degree filter mount is used. Now trying to get refund on the BC462-H.
Please note, Aircraft Spruce ®'s personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce ® assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Both the SD-20 and the SD20-S will fit Rotax 912 and 914 engines on an available vacuum pump accessory pad. It should be confirmed in advance, however, that the engine in question is equipped with the necssary vacuum pump drive gear (some may not). Eligible pads on Rotax engines turn at a ratio of .54 to 1 of engine RPM.
Per B&C the SD-20S looks to be the BC425-H now.
The BC410-H is for experimental aircraft only. The BC410-1 is for certified aircraft.