PTI-Acetone is virgin (not recycled) Acetone that may be used to remove lacquer finishes, for cleanup after painting, and to soften lacquers or acrylics that set up in spray guns or hoses. Acetone (dimethyl ketone and 2-propanone) is a clear, colorless, low-boiling, flammable, volatile liquid, characterized by rapid evaporation and a faintly aromatic odor. It is readily miscible in most organic solvents and completely miscible, in all proportions, in water. Acetone is an excellent solvent for a wide range of gums, resins, waxes, fats, greases and oils. Acetone is ideal for thinning fiberglass resin, cleaning fiberglass tools and dissolving two-part epoxies and superglue before hardening. It is used as a volatile component and thinner for some paints and varnishes. As a heavy-duty degreaser, it is useful in the preparation of metal prior to painting; it also thins polyester resins, vinyl and adhesives. Acetone is not effective on urethanes and should not be used. Use MEK for cleanup on urethane products. Use only virgin acetone. Recycled acetone can damage virtually anything to which it is applied.
ACETONE WIPES KIT (ACT/WC3)
ACT/WC3 Aircraft Detail Kit includes Acetone, wipes and dispensing bucket that all meet and exceed current military and commercial specifications. The dispensing bucket is an airtight container with a gasket to reduce contamination and/or evaporation. ACT/WC3 kit gives you more control over the dispensing and application of your cleaning solution. Because the amount of solution added is measured and fully saturated into each wipe. This results in a max 20% reduction in chemical usage. All these factors make this detail kit the most productive and efficient way clean most any smooth to semi smooth surfaces. 60-wipe Roll. Size: 12"x12.5"
ACETONE WIPES KIT FOR ABRASIVE SURFACES (MEK/WA2)
ACT/WA2 Abrasive Surface Wipes Kit includes Acetone, wipes for abrasive surfaces and dispensing bucket. All components meet and exceed current military and commercial specifications. The dispensing bucket is an airtight container with a gasket to reduce contamination and evaporation. ACT/WA2 kit gives you more control over the dispensing and application of your cleaning solution. Because the amount of solution added is measured and fully saturated into each wipe, a max of 20% reduction in chemical usage. All these factors make this detail kit the most productive and efficient way to clean parts and equipment with abrasive surfaces. 60-wipe Roll. Size: 12"x12.5"
Certification paperwork must be requested at time of order. If certs are required with purchase, please contact us by clicking here or calling sales.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, however it will incur hazardous fees and there cannot be more than one gallon in each box.