FREE SHIPPING ON ORDERS OVER $350 (USA ONLY - SOME EXCLUSIONS APPLY) | 877-4-SPRUCE

Matco Centrifugally Cast Aluminum Nosewheel Nw600

$241.95/Each
Part# 06-00549
MFR Model# WHLNW600

Overview

NW600
MATCO mfg produces the NW600 inch nosewheel for use with aircraft requiring less than 1420 pounds nosewheel load.

The NW600 uses 1.25 inch Taper/Roll bearings. It is 4.5" wide and weighs approximately 3.24 lbs.

The NW600 is designed for the following standards:
Static Capacity: 1420 LBS
Load Limit: 4260 LBS

Product Comparison Table
   
California Prop 65 Warning Symbol

WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov

Reviews

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What size tire does the Matco nosewheel NW600 take [width]. Is a 600 X 6 tire too wide?

The NW600 can use 600x6 tires.

Q: Does the NW600 nosewheel need a tube with a straight or 90 degree valve stem?

The NW600 needs a tube with a 90 degree bent stem.

View in Catalog

View Image View in Catalog