FREE SHIPPING ON ORDERS OVER $350 (USA ONLY - SOME EXCLUSIONS APPLY) | 877-4-SPRUCE

Shock Cord Tool For Piper J3

$337.00/Each
Quantity
Add to Wishlist
Part# 06-16600
MFR Model# M-008-000

Overview

Use with shock cords already on aircraft. With little effort install shock cords on Piper J3 aircraft. Not for use with hydrasorb shock struts.

Documents

Reviews

5 stars

Charles H Verified Purchase

SHOCK CORD TOOL

September 18, 2022

I wouldnt want to try changing Bungees without this tool.

Greg S
October 18, 2019

Bought this tool new and used it to install bungee cords on my Star Duster Too SA 300. Took us an hour and a half to clean the threads well enough so the nut that stretches the cord would travel the entire length of the tool. Im sure it would have taken less time if we had a proper thread chaser tool to clean the threads, but it was after hours and all the local stores were closed. Also the end of the threads dont allow the nut to be removed. I must say while it was difficult to use this tool it would have been impossible to do without it. I just wish they would have done a better job on it as the basic design is good. This was with standard bungees not HD.

Mike R
March 11, 2017

The basic design is ok, but the tool broke on the second bungee install. The threads on the screw galled and i had to cut the nut off. Its needs some revision. Mainly a better grade of threaded rod and a longer length nut plus a thrust bearing on the screw would help greatly. One more thing would be to break all the sharp corners so that the bungee doesnt get cut during install. Tell wagaero to try harder!!!

Dan
March 13, 2021

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Can you publish directions for this shock cord tools use?

We have posted the available instructions. They are blurry but it is all we had available to us.

Q: Will this tool work on a PA12?

Yes, it should work as long as you do not have hydrasorb shock struts on the aircraft.

View in Catalog

View Image View in Catalog