|Seatbelt end fittings for experimental aircraft.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
We have since added the dimensions to the "Dimensions" tab on this web page. Please review it for complete dimensional information.
We measured the I.D. of the hole size. It is 0.39". An AN6 would be the closest sized bolt that would fit into this hole size which is .375 in diameter.
The two longer sides are going to be 2-3/4" long and the shorter side is 2-1/2" long.