|Simplify installation of cabin, carb heat, cabin vent lines. Aluminum flange may be welded or riveted in place. Slip ducting over outlet and secure with clamp.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
I ordered this flange to make an adapter for the exhaust on my portanbe generator and it was perfect for the job. It is well constructed and should last for years.
ALUMINUM FLANGE 2-1/4" 10350-9
I was not surprised at the quality. Top notch. No issues. Super value for the cost.
I have on gotten less than half of my order, but it has been smooth so far
Excellent handlich. I was advised that shipping with priority mail cannot be traced. As the part was only 9 $ I accepted the risk
Simple aluminum flange, installed easily, looks great
Perfect Just what I needed. As described
I used the flange as a spring spacer for the rear shock on a motorcycle, it worked great.
Exactly as described, delivered overnight, perfect!
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
These flanges are made from .063" 6061-0 aluminum.
No, they are a straight tube flange for ducting.
The flange dimension is the O.D. of the flat part that sits flush with the mounting surface, and the ducting dimension is the I.D. of the air duct to be attached to the unit.
Major diameter is 2-3/8" & minor diameter is 1-1/2".
The 10350 flanges do not have any surface treatment on them.
The wall thickness is approx. .070", and the ID is 2.855".
This measures to 1.1".
Diameters for 10350-7: major dia, 2-3/4 & minor dia, 1-3/4
The od of the point where the ducting attaches is 2.25, the od of the flange at its widest point is 3.28, the metal is .058 thick.