This mic plug is just right for my Gonset Communicator and is of high quality. Thank you.

John P Verified Purchase

.206" COMMERCIAL MIC PLUG

Solved the problem with my headset

Just what I needed. No problems.

Great product, works perfectly. The body is plastic but its high quality and feels solid.

Product was exactly what I ordered, what more can I Say

Rapid supply. Product good quality

I bought this as an asapter for my David Clark H10-76 to thr mic switch. It works great .

Don’t buy this plug if you intend to use it in an airplane. Nothing wrong with this plug in and of itself but it is 3 conductor and not 4. It will not fit all aircraft microphone jacks. The proper plug that will fit all should note conformance to M642/5-1. Spruce sells them but they coat 3 times more than this one. I didn’t notice this when I purchased this. It worked fine for a couple years and probably a dozen different airplanes, but I recently rented an airplane and found the pilot microphone jack was not compatible with this plug. Headsets do not come standard with this style plug.

Plug was mailed January 8 by Canada Post Expedited. Has not arrived yet (January 23). Perhaps it was lost in the mail? Thanks.

I bought this to replace a failed plug on a David Clark headset. Overall the new plug is OK. There were no instructions for wiring it, so I disassembled the old plug and used an ohm meter to map the 3 wires. The ground lead on the new plug was somewhat difficult to solder. I used heat shrink material as a strain relief. The crimp to hold the wire in place is weak, so after verifying the plug worked I filled it with black RTV to prevent wires from breaking or pulling out. Hopefully this will last awhile.