These Clear Kits are ideal for sealing / clear-coating surfaces such as concrete and wood, as well as for wetting fabrics that require a clear, waterproof finish. Odourless and non-toxic, It can be applied indoors or outdoors without masks or ventilation. This self-leveling kit is applies at approximately 10 mils finish thickness. It provides a durable, light reflective floor with excellent adhesion qualities. It’s easily roller applied. The Clear Kit is non-shrinking, and resistant to to water, acids, other solvents. It will never peel, flake or chalk when properly applied. Typical use include Warehouse Floors, Aisle ways, Storage Areas, Industrial & Commercial Floors. |
My order came very quickly. The product, though more expensive than comparable epoxies, was well worth it. It works exactly like other much more toxic products. So far no noticeable odor, and no headaches! It dried crystal clear and super hard. Thanks!
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
This material can be thinned 2% with Denatured Alcohol. The manufacturer does not have any information for a spray application.
Yes it can be wet sanded, but the manufacturer recommends dry sanding. Yes, it can be polished.
It is approx 100 sq ft per gallon. Normally 2 coats will get you a 10 mil build. The first one just seals the wood.
Per Vendor: No, they are not hazardous materials.
They do not offer a ratio pump system, we do offer a counter top adjustable ratio pump, p/n 01-16010 , used with many epoxy systems.
EcoPoxy Resin and Clear Hardener should not be applied when surface temperature is above 90 degrees F. or below 60 degrees F.