FREE SHIPPING ON ORDERS OVER $350 (SOME EXCLUSIONS APPLY) | 877-4-SPRUCE
Thumbs 1
Thumbs 1

Aerotar 15550142 C172 1/2 Clamp

$50.50/Set
Quantity
Add to Wishlist
Part# M2376
MFR Model# M2376-10

Overview

Aerotar 15550142 C172 1/2 Clamp, #M2376.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

  • Frequently Purchased With
  • Customers Also Viewed
  • Related Items

Reviews

I really like this product as I had seen it on a clients plane. I put it on mine where the spark plug wires had passed through the baffling deck via a hole with a grommet filled with silicone. Once I installed these it really gave a nice professional looking installation look. The holes where the wires are secured in are tight. It takes some pressure to fully close the halves together and ensure the small holes and pins on both ends line up and connect. Note: the holes are truly AN-3 sized. Good product overall.

Tailwind A
August 15, 2020

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Concerning part number M2376, does a set refer to two of the seals. That is, accommodations for six wires?

No, the set is for the two halves that secure three wires.

Q: What is the distance between the two outer bolt holes?

2-1/4 inch center to center.

Q: can this item be enlarged to accommodate 6MM wire?

Per manfuacturer: "Those clamps have standard size as per original dimensions from the manufacturer, if we enlarge the clamp then it won't serve its purpose on the on riser that connects to the muffler, there will be an air gap that will expose the gases to the engine. Nonetheless, if the enlarged clamp is not meant for that application we can definitely engineer an enlarged clamp."

View in Catalog

View Image View in Catalog