Nylon, a polyimide resin, is a light yet tough thermoplastic material. Its density is approximately . 041 lb./cu.in. It is a tough, resilient material with a low coefficient of frictionabrasion tests show that Nylon loses less material than do many metals, other plastics, and hard rubber. It can deform under load, then return to its original shape. Nylon retains its impact strength over a wide range of temperatures (-60° to 400°F). It has good resistance to most chemicals. It can be easily machined on most standard metal working machines, power hacksaws, band saws, or circular saws. It is desirable to use a saw with a coarse tooth blade.
SOLD BY THE SQUARE FOOT (12" X 12").
Smaller pieces are available. Order as follows:
Came very quickly and product was perfect.
The part was a little warped, but adequate for my needs. Shipping was a bit higher than I expected. Good response time.
It took me more than a hour to clean the stickers off of it so i could use it.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.