(1/4-28 Threaded End) This control has 1/4-28 threaded ends (nonswiveling) and 3-1/2" stroke. It has Teflon™ casing liner for use in high-temperature areas such as engine compartments, and .078" diameter stainless steel inner cable to minimize backlash. Stocked in the following lengths.
Made in USA
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
functions great. I would suggest you stock the 3 foot length in this. I would think that is the most common at least for us.
The cable is listed as having 10-32 threads on both ends. using the guidance on the web page, I bought AN665-21R threaded clevis tie rod ends for the cable. When the cable arrived I found that the cable was threaded with 1/4-28 thread and the parts I bought were the wrong size. Now I have to go through the hassle of returning everything.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The cable housing is 1/4" O.D.
Right hand thread.
No, this is intended for use in experimental aircraft only. The ACS A-790-12 and A-800-12 are the only ACS controls that are FAA Approved.