Part# 09-17377
AircraftDescriptionQtyPart No.
Piper PA-25, SN25-2000 to -4171Shock Strut BootsPAIR09-17377


To keep your aircraft components clean from contamination by dust, grime and dirt, install these quality covers made from black vinyl. No mounting hardware included.
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm -


Installed on a Cessna 172. Fit great no issues at all.

Sunset E
September 2, 2017

Stitching was off on part of the velcro tab. Will need to re-sew It before installation. Otherwise seems like a good quality part

May 27, 2019

I purchased the Beechcraft gear boots and could not get the snaps to close. Poor quality control seems to have done them in on this one. The actual boot itself was good quality and fit perfectly. To bad the snaps didnt work.

Brian K
March 9, 2017

quality was cheap... not for me... sorry! returning

Mitchell L
October 20, 2020


Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What are the measurements of these boots? We need boots for Piper Comanche PA-24.

All of these boots have unique measurements. If your aircraft is not listed, we can do special order boots. The two options would be to send us your original boots to copy or give us a detailed pattern with exact dimensions. These would be non-cancellable and non-returnable. To set up the order, please contact sales at 977-477-7823 or email using the "Contact Us" link in the upper right portion of every web page on our site.

Q: Are these unlock boots RH & LH PMA FAA approved?

No these are not FAA approved.

Q: Could you please provide the measurements of part number 09-17362? Roughly what is the width of the bottom when shaped in a circle and the height?

The height is approximately 6" from bottom of sewn seam to the top of the hole when laid flat. The diameter of the bottom circle when opened is approximately 6-1/4".

View in Catalog

View Image View in Catalog