Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Squeezer Set AT108AP-3/32 1 Pc
MFR Model# ATI108AP3/32
FREE Shipping
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
|
Rivet Diameter | Body Length (L Dimension) | Part No. |
|---|---|---|
| 3/32" | 1/4 | 12-01661 |
Overview
|
For Swivel Hand Rivet Squeezer or any snap Type .187 Shank Diameter Squeezer
Instructions for Selecting Rivet Sets: WHEN TWO CUPPED RIVET SETS ARE USED: The sum of the two rivet sets "L" dimension should equal the closed height dimension of the yoke minus the total thickness of the material being used. WHEN TWO FLUSH SETS ARE USED: The sum of the two rivet sets "L" dimension should equal the closed height dimesion of the yoke minus the overall length of the rivet after it is driven. WHEN ONE CUPPED SET & ONE FLUSH SET ARE USED: The sum of the two rivet sets "L" dimension should equal the closed height dimension of the yoke minus the total thickness fo the material being riveted and the height fo the finished rivet head driven by the flush set. If necessary, select rivet sets a little short and shim to proper length with hardened shims listed in the table. The closed height dimension of the yoke referred to above is the opening available when jaws of plunger are in extreme closed or forward position with both rivet sets in place.
|
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Reviews
I ordered this 3/32 universal rivet set to supplement the one I had from Cleaveland tools. I needed one with a smaller diameter head, and this one fits. The head finish is fantastic, and the side is marked with the size, which is helpful. The stem and detent both need some work, however. The stem onbthe set I received was 0.0008 to 0.0012 too big. I had to sand, polish the stem to even fit into my squeezer yokes. When I first tried to insert it into my squeezer, it got stuck with only 1/8 inserted. After I pried it out of the squeezer stem, I tried two other yokes and had the same results. After removing enough material from the stem to fit, the metal detent was way too stiff to use. I pressed the set into a yoke, and had to use a punch to drive the set out, past the detent. I ended up removing the detent so I could remove the set by hand. If anyone purchases this rivet set, test the fit on a yoke with a through-hole, so it can be driven out.
Verified Purchase
Squeezer Set AT108AP-3/32 1 Pc
Q&A
Please note, Aircraft Spruce ®'s personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce ® assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
