|Truss-head non-structural machine screws made of carbon steel, cadmium plated. Minimum tensile strength 55,000 PSI. Available in slot head or Phillips recessed head.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
what I wanted
what I wanted
Fast shiping .
Good quality hardware with fast shipping
Great product and good shipping response.
Exactly what was ordered. good shipping time. Thank you,
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, they are measured from the bottom of the head to the end of the screw, the threaded portion.
No, it is a standard 4-40 thread.
The first number is the size, or diameter, and the dash number is the thread count per inch. A #4 screw is .112" diameter.
You may want to consult with your A&P for more details of which would be better for your application. We suggest using the hardware recommended in the aircraft parts and maintenance manuals.
No, any strength difference would be based on the thread type. These all have a 55,000 psi minimum tensile strength.
That is the length, R8 is 1/2 inch.
AN526 screws are Truss head.