Matco Centrifugally Cast Wheels Internal Caliper W62

Part# 06-02110
MFR Model# WHLW62



MATCO mfg produces a superior 6 inch wheel and brake assembly for use with aircraft requiring less than 1185 lbs per wheel. This model uses 0.75 inch TAPER/ROLL bearings. (Check the product comparison table for other bearing and caliper configurations).


The W62 is a 6 inch wheel with 4.375 inch width with an additional 1.23 inch caliper spacing. Bearing spacing is 2.52 inches and axle spacing is 1.25 inches. The total weight of this wheel and brake assembly is 7 pounds. The bearing axle diameter is 0.75 inches.

Performance The W62 is designed for the following standards:
Static Capacity: 1185 LBS
Load Limit: 3560 LBS
Maximum Accelerate/Stop Kinetic Energy: 189604 ft-lb
Torque Rating (@450 PSI): 1988 in-lb

Product Comparison Table
California Prop 65 Warning Symbol

WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm.



Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: what brake pads are used on the Match W62 wheel?

You would use the BRL-1 (06-00571) kit with that wheel and brake combo.

View in Catalog

View Image View in Catalog