UMA hall effect tach sensor - screws into vent plug of slick magneto for tach signal to EFIS. 6' lead length. |
I installed on a Slick mag for use with a MGL rpm-1 tachometer. Simple installation and works flawlessly. Just make sure you install it in the correct vent port - there are two per mag. I had to rotate my mag to gain access and then re-time it when I was done.
Yes, the MGL tach sensor (11-08334) will work with the MGL E1 (11-05578).
Yes, all MGL sensors are compatible with the RDAC unit.
Per the Manufacturer, part # 11-08334 Will work with the JPI EDM-700/EGT 701.
This has a 6 foot lead length.