For soft copper, aluminum and thin wall steel tubing.
For 1/8", 3/16", 1/4", 5/16", 3/8" O.D. tubing.
Makes up to 90° bends.
Calibrated markings for making accurate left-hand, right and offset bends. Ninety degree start requires less effort – making bending fast and easy. For soft copper, aluminum and steel.
367-FH For 1/8", 3/16" and 1/4" (3 mm, 4 mm and 6 mm) O.D. tubing. 9/16" (14.2 mm) radius to center of tube. Wt. 0.5 lbs.
368-FH For 3/16", 1/4", 5/16" and 3/8" (6 mm and 8 mm) O.D. tubing. 15/16" (17.5 mm) radius to center of tube. Wt. 1.0 lbs.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
These aren't worth much - they tend to gouge the sides of aluminum tubing when used and only make 90 degree bends anyway. Try Part # 12-01042 - it can make clean 180 degree bends. Much better quality and versatility for only $10 more.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.