THE AVIATION SUPERSTORE FOR ALL YOUR AIRCRAFT & PILOT NEEDS | 877-4-SPRUCE

Clevis Bolt Undrilled AN24-23A

$4.40/Piece
Part# AN24-23A
MFR Model# 06968-1
Dash No.GripLength
-231-1/81-15/32

Overview

Clevis bolts have a slotted brazier type head. They are special-purpose bolts for use where a large shearing stress occurs (never in tension). Manufactured and cadmium plated in same manner as AN3 - AN8 aircraft bolts. Minimum tensile strength 125,000 PSI. Available with drilled or undrilled shank. Add letter "A" after dash number for undrilled shank. Prices fluctuate on clevis bolts.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Bolts worked as expected but very expensive.

Rodney L
April 13, 2018

i purchased the same clevis bolt from another aircraft supply house in the Midwest. It was not cad plated. It just did not look nice for the project. This bold looks crisp and appropriate for the restoration. Much higher quality product.

Jim
February 25, 2017

These bolts were purchased to replace previous purchase of same bolts. Previous bolts threads were so damaged, it was impossible to thread a castellated nut onto them. The newly purchased bolts had the same problem, just not as damaged. Threading the nut was difficult, but not impossible. Also, why are these almost $10 each?

Mike A
November 21, 2019

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Is grip length from head to beginning of threads?

The grip length is measured from under the head to the start of the threads.

View in Catalog

View Image View in Catalog