Band Material: Corrosion Resistant Steel
Cushion Material: Fluorosilicone - For elevated temperature usage in petroleum based fluid contaminated areas. Unaffected by ozone. Not resistant to phosphate ester based fluids. Color is solid blue.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
High Quality stainless clamp, liner will withstand engine compartment heat
High quality, stainless clamp recommended for higher temps and worth the price
High Quality Adel type clamp with Fuel resistant material. Wish it was also available in larger diameters, I used Adel clamps to mount my boost Pump and Filter that required -26 and -30 sizes.
Great for clamping wires on engine mount. Easy to install, rust free.
These work well to clamp onto a Vans RV engine mount when securing wires firewall forward.
If they work as advertised, I’ll know in several years. Look good, and easy to install. It would be easier if they came with screws and nuts.
They are easier to install than the aluminum series
Looks to be a good product. Time will tell.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The band is made from 321 corrosion resistant steel. The diameter where the stud would go through is .199" to .209".