|Quart Kit (Yields 2.5 qts) Incl. catalyst & reducer|
|Gal. Kit (Yields 2.5 Gal.) Incl. catalyst & reducer|
|Reducer E-500 (Reduce 50%) Quart|
|Reducer E-500 (Reduce 50%) Gallon|
|An excellent clear gloss epoxy varnish for interior and exterior use. It provides superior weather durability and excellent chemical and solvent resistance. Can be used over a one component varnish primer if desired. Mixing ratio is 2 parts base, 1 part catalyst. Can be ordered as a kit which includes base, catalyst and reducer, or each component separately.|
Make sure to purchase pumps with this. Makes use so easy.
Easy to use. Good stuff
Used it for the first time when re-varnishing some original wooden spars for a J-3 restoration. We just sanded off most of the old varnish as best we could, wiped off the dust with a clean, damp rag and then next day applied the Poly-Fiber varnish directly over the old finish and it worked exactly as they said it would - no reaction between the old and the new finish, no de-laminating, no fish-eye... it just worked perfectly. AAA+
great product, swift service
Yes, with the proper preparation, it will adhere to polyurethane.
Yes, it is designed to replace one part wood varnish. This 2-part epoxy varnish is a much better product.
Per the vendor: Though it can be done, generally there is no benefit to epoxy sealing the wood components prior to bonding with T88. The T88 will perform very well by simply applying it to both surfaces and taking measures to not over clamp the joint.
Epoxy varnish is chemical resistant, unless it is submerged in MEK for a long period of time it should not effect it.
This is best used at 70 degrees F. Any higher than this will take much reduction and lower than this will take ventilation to make sure the air is clear from someone breathing it in. On the low side the film may stay open for a long time and allow garbage in the film. On the high side, the reason for more reducer is to stop the film on top from sealing in solvent beneath; this causes bubbling.
EV400 is the varnish and EV410 is the catalyst, they need to be used together. This will work fine with T88.
Stain should not present a problem, either water based or solvent. Make sure the stain is fully dry before encapsulating. Keep in mind epoxy can not handle sun exposure. If outdoor function, urethane varnish would work better.
Technically there is not a minimum temp. The colder it is the longer it will take to cure and ideally you would want to be as close to 77 degrees as possible. Just allow extra cure time the colder it gets.
The Reducer and Varnish have four year shelf lives unopened.
The Catalyst has a two year shelf life unopened.
After they are opened, our ability to know is somewhat limited. Dependent upon the environment, how much material is left in the cans and how tight are the lids, they could last for a very long time. The Catalyst is most subject to deterioration with exposure to air, light, heat and moisture. You will know it has a problem if it turns to a very dark tea color.