Slick two wire clamp assembly. # M2755SP
.281" Diameter hole.
Exactly what I needed!
SLICK M2755 TWO WIRE CLAMP ASY
Excellent and works as one might anticipate. I might add that ACS also sells a Slick Single Ignition Wire Clamp, Slick number M2754 and Aircraft Spruce part number 08-04392. I replaced my clamps as I discovered that the plastic liner for the clamp over time deteriorates and then with more time, the ignition cable will start to wear thru and then intermittently short to ground leading to a rough running engine. The big problem is with the intermittently, and hence will usually not show on a mag check but upon takeoff or in cruise, then the roughness starts. Also because the problem is intermittent, the affected plug may not foul or at least cleans itself, hence one does not know what the problem is. I found all this out when a fellow aircraft owner, (C-182), ended up first rebuilding the mags, and then upon later installation of two new harnesses, discovered the worn ignition wire clamps.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, it is our part number 08-04392.