Note: Please review application guide below to confirm correct part number for your aircraft.
Lord Engine Mount Application Guide (PDF)
These compression type couplings consist of bonded rubber joints pressed into the sockets of metal hubs. These dynafocal engine suspensions provide proper flexible support to isolate engine vibrations and reduce noise transmission to airframe structure in all aircraft applications. Careful design assures maximum strength to hold the engine under ultimate load and emergency conditions. Suspensions also distribute loads in most desirable patterns, control engine motions, accommodate thermal expansion and manufacturers’ tolerances.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Excellent product. Replaced all 4 on left engine ( Aztec PA23-250 ) and no more vibration! Had one mont that had a small crack and replaced it. That caused a bad vibration so replaced the other three even though they appeared to be just fine. Now the engine is running very smooth and no more vibration. Fast delivery.
Arrived in a timely manner, already installed. The removed mounts are ten years old and were drooping, so it was that time. These look great and no vibrations.
In stock, Quick delivery, Competitive price
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No. They do not come with bolts or washers. This will be an aircraft application where you will need to take a look at your parts manual to find out which part number bolt and washer you will need for your application.
Yes, these are priced and sold each. Two halves make up one mount.
Ordering qty 1 will give you what is shown in the photo.