Type | MS No. | Thread | PN |
---|---|---|---|
Cad Plated | -- | 7/16-20 | AN363-720 |
The AN363 all-metal stop nuts are designed for use in high temp installations (up to 450°F). Fabricated from cadmium plated per specification QQ-P-416C. |
![]() |
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov |
These are not 10-32 nuts
NUT, STOP AN363-720 (PACK OF 10)
NUT, STOP AN363-720
NUT, STOP AN363-720
Part was as expected as I had spec sheet for part. That said as mentioned elsewhere picture does not match part which could be problematic if you are expecting what is pictured.
NUT, STOP AN363-720
As listed, as expected. However the picture is not representative of the AN363-720 nut - the nut is a slotted collar stop nut.
NUT, STOP AN363-720
NUT, STOP AN363-720
NUT, STOP AN363-720
NUT, STOP AN363-720
These where out of stock, when can I expect shipment?
Only issue I have is I ordered 30 AN176-13A bolts also but they went back order, I did not receive a date that I would be getting them. Thank you
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
It is is a stock photo and representative of the series. We do not recommend ordering by photo for hardware. It is always best to order by specifications or AN / MS number.