Alcor EGT gauges are aircraft quality gauges which will provide precise monitoring of engine temperatures. PMA/FAA approved. Basic system kits include the 2-1/4" instrument, one lead and one probe to monitor the EGT for a single cylinder. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Exact fit. Easy to install.Kit comes with new tiny screw and nut set insulatoe sleeve and zip ties.
86255 Alcor EGT Probe Type K
Not the most exciting purchase, but it did include a nice snakeskin protector for the wire junctions.
42525 Alcor EGT Type K 90
Whats alive again!
86255 Alcor EGT Probe Type K
Aircraft Spruce is the best at expediting shipping and delivery
86255 Alcor EGT Probe Type K
Great product. Works perfectly in my Skylane.
Alcor Basic EGT System
I had a failure of my Cylinder #1 EGT Temperature probe recently, I ordered this new one. It took about 2 hours to install properly, and it worked fine on the test flight. In fact, I discovered that this version of the EGT probe is actually built much better than the original was (it seats much better into the exhaust manifold). The electrical parts were of sufficient length for Cylinder #1, but might not have been for others. The wiring was compatible with my current wiring.
86255 Alcor EGT Probe Type K
Received the order quickly, it was complete with everything you needed for installation. Instruction are easy to follow and the installation process went smoothly. Very pleased with purchase.
Alcor Basic EGT System
Worked great after install.
86255 Alcor EGT Probe Type K
OEM probe fits and works perfectly. Nothing better than “plug and play”.
86255 Alcor EGT Probe Type K
Alcor Basic EGT System
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The large ticks are at 100 degree each starting as 1200F and the small ticks are 25 degrees each.
This unit uses a 3 1/4 - 3 1/8 hose clamp. Please check with your local Aviation office to see if this PMA is ok for your aircraft.