|This tool is designed for light production and features high speed push-pull, smooth, spiral action. Sized #4 through #10 adequate for brass, aluminum, and steel. Sized #4 through #8 adequate for stainless steel. Provides easy on-and-off threading of rivet nut with push-pull knob. Adjustable anvil for different length rivet nuts. Made in U.S.A.|
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Really good and easy to use, it greatly reduced the time to install rivnuts. Works much better then all in one rivnut tools.
I LOVE IT! This is one of the best tools i have used for my job as a repair man. Quick and easy.
I ordered 3 of these. The first one came and was so rough in operation that I had to take it apart and clean out the rust and lube it to get it to function. The other two that were back ordered came in even sorrier shape. One locks up and the other is only smoth if handle is kept squeezed. Now I will have to dissasemble these and correct assembly problems. The quality (and quality control) on these speed drivers is non existant. Very unhappy with manufacturer (not vendor - AS).
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.