|Azusa Tube # 7116 11-600 X 5
|Inner Tubes for most Azusa variety tires
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
These are a true 90 degree valve stem with the valve stem being very near the center of the tube. These tubes work very well for the Azusa 2 piece experimental wheels. The Azusa 2 piece wheel is a split wheel with the with valve stem placement in the middle of the wheel. Meaning that each half of the wheels has a 180 degree cutout for the tube valve stem. A true 90 degree valve stem is required for this application. The rubber thickness is near heavy duty on these tubes as well. Be careful as some tubes that claim they have a 90 degree stem are actually 45 degrees and the stem is offset further tpo the side of the tube.
Tube is of good quality, good 90 degree bend but valve is not on center. I also had to modify rim to make them work.
Another reviewer said These are a true 90 degree valve stem with the valve stem being very near the center of the tube. I ordered the Azusa tube #7125, and the 90 degree valve stem was NOT even close to the center of the tube. It was about 25% of the way around the tube. I ended up modifying my wheels and moving the valve stem hole to better accommodate the offset valve stem. If I ever do end up with a proper tube, it will still fit the wheels!
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, tube 7116 is equipped with a 90 degree bent valve stem.
06-00075 is a 90* stem. 06-01590 has a straight stem.
No, the tube 7121 has a straight valve stem.
No, this tube has a 90 degree valve stem.
From the 90 degree bend to the cap, the stem is approx 1-7/16 inches.
We have no data supporting this tubes being used for nitrogen.