FREE SHIPPING ON ORDERS OVER $350 (SOME EXCLUSIONS APPLY) | 877-4-SPRUCE

Th-55 Trainer Model

$239.95/Each
Quantity
Add to Wishlist
Part# 13-10841
MFR Model# HTH55

Overview

The TH-55 Trainer or better known as the TH-55 Osage was two-seater light pilot training helicopter used by the U.S Army. The Trainer was initially designed as a fully-glazed cockpit with seating for two pilots, or a pilot and passenger. It also had an open-framework fuselage and a three-blade articulated rotor. Manufactured by Hughes Helicopters, the TH-55 Trainer first flew in October 1956. It was produced as the Model 269 family of light utility helicopters, some of which were marketed as the Model 300.

Also known as the Hughes 269 was created with a fully articulated, counter-clockwise rotating, three-bladed main rotor, and a two-bladed tail rotor that would remain as distinctive characteristics of all its variants. It also has shock absorber-dampened, skid-type landing gear. The flight controls are directly linked to the control surfaces of the helicopter so there is no hydraulics in the 269. There are generally two sets of controls, although this was optional on the civil 269A. The TH-55 Trainer was powered by a Lycoming O-360-C2B four-cylinder horizontally-opposed air-cooled engine providing a top speed of 136 km/h and a flying time of 2.6 hours.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

Reviews

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.