Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
AeroLEDs Sunray Plus Landing Light Non TSO
MFR Model# 01-1150
FREE Shipping
Overview
|
The SunRay Plus is a wing-mounted LED (Light Emitting Diode) landing light with a built-in wig wag feature in addition to its standard operation as a landing/taxi light. The SunRay Plus is a very intense light source that uses 4 high power LED’s to produce up to 1,000+ lumens of light and 30,000 candela using 10 watts of power. Each SunRay Plus light uses less than half the power of an equivalent 55 watt halogen light while producing more usable light in a more narrow beam. The LED light source last up to 50,000 hours of constant operation, so you will never have to replace this light once it has been installed. It will outlast both Halogen and HID lamps. The SunRay Plus is protected against overheating with a built in protection circuit, is protected from lightning transients and ESD, voltage spikes, reverse voltage, and undervoltage conditions. Polycarbonate leading edge windows are commonly used with wing-mounted landing lights, and are typically available for most airplane types from a number of third-party suppliers. This light is small enough to fit in the wingtip cutout found in Van's RV kits. |
 |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Specifications
- Power: 10 Watts
- Voltage: 9-36 VDC
- Lumens: 1,000+
- Lens Material: Polycarbonate
- Candela: 25,000+
- Beam Angle: 10 Degrees
- Rated Life: 50,000 Hours
- Temperature Range: -55C to +70C
- Weight: 5 oz
- Dimensions: 2.65″ x 2.65″ x 1.61″
Documents
- Installation Manual (PDF)
- Tech Data Sheet (PDF)
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
10W
The two holes in the front are 6-32 thread, and are 1/4" deep. There is also a 10-32 threaded port on a side surface. Installation and tech data information is listed in the Documents Tab on our web page.
These are priced and sold individually, one per order.
This is not waterproof but it is water resistant. Meaning if it was sprayed with a hose it should be fine but it cannot be submerged in water.
Per Aeroleds: We do not know of an RF noise issue with this light. We do recommend using shielded wire if the wires are going to be run near radio wiring just in case.
