THE AVIATION SUPERSTORE FOR ALL YOUR AIRCRAFT & PILOT NEEDS | 877-4-SPRUCE

Dremel 543 Cutting / Shaping Wheel

$19.99/Each
Add to cart for current price
Quantity
Add to Wishlist
Part# 01-01056
MFR Model# 543

Overview

For cutting and shaping on soft and hard woods, fiberglass, plastics and laminates (not metal.) This versatile wheel is coated with tungsten carbide grit for long life. It is coated on both sides, so it cuts and finishes in one operation.

User Tips

  • Use the edge of the wheel for
    cutting and slotting.
  • Use the "face" of the wheel for shaping.
  • Do not use on metal.
  • For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
   
California Prop 65 Warning Symbol

WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov

Features

  • Cuts 33% deeper than former Cutting/Shaping Wheel...up to 1/2"
  • Ideal for cutting and shaping soft and hard woods, it can also be used on fiberglass, plastics and laminates.
  • Wheel coated with tungsten carbide grit for long life.
  • Coated on both sides, so it cuts and finishes in one operation.

Specifications

  • Bit Diameter Inch 1-1/4"
  • Bit Diameter mm 31.8 mm
  • Color Code Red
  • Description Cutting/Shaping Wheel
  • Shank Diameter 1/8", 3.2 mm
  • Thickness .070", 1.8 mm
  • Model Number: 543

Reviews

This blade was used to cut Pergo Extreme laminate - using a Skilsaw to cut the laminate longways resulted in a very bad, bad cut - so I was told this was a much easier way - I did need a better Dremel saw than the 100 model from Walmart, I needed the two-speed Dremel for slightly more from Home Depot - but the blade did very well - and apparently the laminate is a tough surface to cut -

Dennis
August 1, 2021

I ordered two, received two, took one to my shop and my wife picked the second one up, still in the plastic package, and the plastic was pushed in, and about 1/3rd of the cutter blade was bent back. I will try to remove the center screw and bend it in a vice, really dont have the time to send it back etc....Live is too short...

Thomas L
October 8, 2020

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Can this cutting wheel be used on carbon fiber and Kevlar ? If not what would be the best choice?

There have been no tests done with Carbon Fiber or Kevlar but it should work with no issues.

View in Catalog

View Image View in Catalog