10-00488 EGT Sender 1"-2.5"
"K" type sending unit with 4-ft. lead.
10-00489 EGT Sender 8x1.0mm
8mm threaded EGT Probe (N-RTX)
10-02294 EGT Sender 1" - 1-3/4"
4 Feet Metal Shield Wire
Similar to Falcon Gauge
Made in China
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
So far , it is of high standards, and works as advertised.. Will report later after flying season.
SWIFT EGT CLAMP 32 TYPE PROBE 3/4" TIP 48"
SWIFT EGT PRECISION BAYONET TYPE PROBE
Very good product and shipping service!
Seems nice and works with westech dual egt gauge on r582 cheaper than westech one. Time will tell on longevity.
Got it quick. Works perfect. Thanks!
The Swift Gauge probe worked very well and was easy to instal in my experimental home built airplane.
easy to install and works very well. Fast shipping Thank you
The jumper wire was also included, easy install.
Perfect, and fast delivery. Ordered 09-26, delivered 10-02. Does this 10-02294 SWIFT EGT sender is OK w Westach Dual EGT/CHT gauge (2DA1 10-01239) ? ...
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Part # 10-02294 is a Type K EGT Clamp Probe.
As the Falcon EGT Probes are not TSO'd, they are not to be used in certified aircraft.
4 ft lead.
Each company only ensures compatibility with the manufacturer’s recommended probes. Since this has not been tested, this is not recommended combination.
The EP-002 has a temperature range of 400-1700 degrees Fahrenheit.
Type K wire is used for extending EGT leads.
These probed are grounded.
Yes, this probe can be used int he Rotax 582.
No, they are not compatible.
Per the manufacturer this is type K.