All metal floating anchor nuts. MS21059 ( F5000 ) and MS21061 ( F2000 ).
Anchor nuts are designed for blind mounted applications where it is impractical to use hex nuts or where it is desirable to have an attached nut for ease of maintenance.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Very fast service and accurate shipping.
Excellent, work like they should not like the 80 of #8 I received the last time
I ordered these with two other parts which were out of stock. I was OK with that but needed the anchor nuts sooner. They came the next day! And of course they are very good quality. Thank you ACS!
Perfect for providing an attached nut that moves just enough to insure alignment.
These were for the rear seat rear legs in a cessna 172L. The originals had gotten stripped out over time, and werent the floating type. These floating anchors allowed more wiggle room in getting everything to go together. I was a little disappointed with the shipping time. Ordered them around 430 pm est on a monday with priority mail shipping, and they arrived Thursday afternoon about 3 PM. I thought they would arrive a day sooner.
A little confusing to find the standard two lug floating nut plate as they are listed in the right hand column and the picture is the second picture which must be selected. But these are the nut plates which are the same size as the standard non-floating and work well.
The picture shows a single lug and is a little confusing regarding the number for a two lug floating nut plate
The part pictured in the listing does not match the part that was sent.
The part pictured on my printed order does not match the part ordered. If I had done an in depth review of the order, I would not have able to discern what part was actually shipped .
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
This is for a 1/4-28 threaded fastener, so the hole would have to be at least 1/4" for the fastener to engage the threads of the anchor nut.
The F5000 anchor nuts we offer require 3/32" diameter rivets for installation.
The rivet hole spacing is .688" for anchor nuts up to 10-32 threads, and 1" spacing for 1/4-28 to 3/8-24 threaded units.
The bolt hole accepts a 8-32 threaded bolt. The rivet holes accept a 3/32" diameter rivet.
1.051 inches long, 0.250 inches height, between 0.290 inches and 0.422 inches wide.
0.948 in long, 0.25 in high, .69 in mounting hole center to center.
10-32 thread, MS21061L3 is the single lug option.