THE AVIATION SUPERSTORE FOR ALL YOUR AIRCRAFT & PILOT NEEDS | 877-4-SPRUCE

REAL GASKET RG-360PRT-6 CONTINTL PUSHROD TUBE SEAL KIT - 6CYL

$84.80/Each
Part# 08-01327
MFR Model# RG-360PRT-6
ApplicationPart No.
IO/TSIO-360 complete engine (6 Cylinder)08-01327

Overview

These seals from Real Gasket Corp. provide 37% more sealing area at the point of contact with the pushrod tube, and vector spring pressure by its beveled top and companion washer. FAA Approved for the Continental engines shown below.
   
California Prop 65 Warning Symbol

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.

  • Frequently Purchased With
  • Customers Also Viewed

Reviews

Just what was needed to stop my oil leaks in the tcm io360

Henry H
September 17, 2017

purchased the kit for an IO 360 Followed real gaskets install instructions...Ran the engine, flew the plane, they leaked. I cleaned engine and they kept leaking... took a 4 trip and everyone of them leak !! Now, doing the job over again with factory seals !! NEVER AGAIN will I use Real Gaskets !! I only gave them 1 star because they were at least gaskets.

Airworks U
June 12, 2019

I bought the full set for my IO-360 to fix those pesky oil leaks. During install, I noticed even with the rubber seal stretched over the push rod tube, it wasn’t nearly as tight sealing in the engine block. The original OLD seals fit tighter!!! I called the company that made the kit and they explained that this is normal and the spring would help expand the rubber in the block.... NO DICE. They all leak. We have to do the job again and we will be buying the original seals from continental. Why would this “upgraded” kit fit so loose... The company explained the rubber parts are ordered in bulk from CHINA by the thousands.. must have got a bad batch. Do not waste your time with this kit. The old rubber seals do a better job... Bis kit was installed on a 1979 Cessna hawk XP...

Andy
April 14, 2018

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Does the cylinder kit contain seals for both ends of the push rod tube?

Yes, comes with qty 2 seals, qty 2 washers, and qty 2 o-rings.

Q: Does the Real Pushrod Tube Seal Kit for the IO470 (08-10323) have an STC?

You would want our part number 08-01326 for that engine. These are FAA PMA'd.

View in Catalog

View Image View in Catalog