|Material||Fine Thread||Part No.|
Less 20% for quantity 100/Part No.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
HEX NUT AN345-428 MS35650-3252
The threads are the correct 5/16 x 24 but the hex is 14mm, not 1/2 inch
Just be advised these received nuts have a 9/16 wrenching hex, not the AN-5 standard of 1/2 wrenching hex
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, AN345-428 has right hand threads.