FREE SHIPPING ON ORDERS OVER $350 (USA ONLY - SOME EXCLUSIONS APPLY) | 877-4-SPRUCE
Thumbs 1
Thumbs 1

FILLISTER HD SCREW MS35265-45

Packaged Items
SinglePack of 10
Part NumberTypeMS Dash #Length
(in.)
Thread
Size
AN500-A8-8Coarse ThreadMS35265-451/28-32

Overview

All part numbers will follow this format: AN###. To further distinguish between the part numbers, you'll notice that a dash ("-") has been added, followed by some specific variation of more numbers. If there is an "A" after the dash, the part is cadmium plated, Type II, Class 3, with a drilled head. If there is NOT an "A" after the dash, the part is Cadmium plated, Type I.

AN500 (coarse thread) and AN501 (fine thread) slotted fillister head screws are fabricated from carbon steel. Tensile strength 55,000 PSI

AN502 (fine thread) and AN503 (coarse thread) drilled head, slotted fillister head screws are fabricated from steel meeting specification MIL-S-6050. Tensile strength 125,000 PSI. Cadmium plated, Type II Class 3.

   
California Prop 65 Warning Symbol

WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov

Reviews

Just as advertised.

Rod R
April 23, 2021

My first order was to see if these were correct length(no grind down to fit) for SU Carburetors Suction Chamber screws,This is my 2nd order of these Fillister Head screws as they are better than stock head diameter and of course Safety Wire Drilled !! Wont use anything else on my Carb Rebuilds !!

Robie
January 12, 2021

1st order to make sure they were correct for my carb rebuilds !! And they are perfect for 60s era SU Carb resto race look !! Thanx

Robie
December 24, 2020

As described, fit well, functions fine. Its a flat piece of rubber with a bunch of holes, so not too much else to say.

Monte K
October 19, 2020

Prefect length for C-85 lower center valve rocker cover when the standard 3/8 length has stripped..

Ralph
June 5, 2020

Well, its a gasket, but it does fit perfectly and my brakes quit leaking, so its a win!

Michael V
April 11, 2020

a screw is a screw....

F. L
January 17, 2020

Great quality and fast shipping.

Steven S
November 13, 2019

Perfect fit and great finish coating. Pricing was very reasonable.

Robert S
December 21, 2018

Its a filler plug gasket. These cylinders dont use a vent.

Joe Z
October 20, 2018

Q&A

Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: will this brake work with disk brakes?

This is a gasket for a scott type cylinder.

View in Catalog

View Image View in Catalog