|AN No.||Superseding NAS No.||Bolt|
AN960 flat washers are used under hex nuts to provide a smooth bearing surface, as shims to obtain the correct grip length for a bolt and nut assembly, and to adjust the position of AN310 and AN320 castle nuts with respect to drilled cotter pin holes in bolts and clevis pins. Available in regular and light thickness.
Light Series Washers:
The letter "L" to dash number indicates light series.
AN960PD-10L is a light series anodized aluminum washer for a 3/16" dia. bolt.
Light series washers must be manually input on order form.
D Series Washers:
The letter "D" to dash number indicates the aluminum alloy series.
Less 20% for quantity 100/Part No.
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
nominal milspec part, no worries
The washers were about 4 days later than the USPS tacking information - NOT YOUR PROBLEM. Just wanted to let you know whats happening with our postal system.
Very good quality.
These are thin and small washers. If you need a thicker heavier washer use the Baffle seal back-up washers.
Slightly gold anodized finish, but different than steel. Is it just my eyes or do aluminum washers seem thicker than steel? The measurements are the same, however
Regular washer, very flat surfaces. Excellent substitute for AN960 where weight saving is a factor.
Great service. Product as expected.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The tech data sheet allows 2024T3 or 2024T4 is allowed to be used for AN960PD aluminum washers.