This durable document holder is made of strong fabric with two clear pockets to hold your aircraft document secure and visible. It comes with two inches of velcro to be placed anywhere that velcro can be applied to.
Dimensions: 8" x 6-5/8"
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Haven’t installed as of this date
NORAL DOC HOLDER VELCRO
This document holder is somewhat larger than the holder currently in the plane. This allows room for registration and air worthiness documents. Velcro attachment allows the holder to be placed out of the way while meeting FAA requirement.
Well-built with quality materials. Only gripe is the smallish size. My DAR issued the airworthiness certificate and operating limitations on full-size (8.5x11) printer paper which is going to require multiple folds to stuff in into the document holder. I also think some extra Velcro around the perimeter would be a good idea but this can be easily added.
NORAL DOC HOLDER VELCRO
Bigger, better velcro on the back is a plus. However, the adhesive needed some contact cement reinforcement to adhere to the surface in our 77 Grumman Tiger. All in all, we purchased two for each side o the plane and they are a very nice addition for holding the AWC, Title, checklist, etc.
I was expecting more velcro on the edges of the holder rather than on big square of it in the middle. I am going to add edge velcro because the edges stick out and could get caught on stuff. Other than that, the document sleeve is easy to access and use, it will do
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The dimensions of this holder are approximately 8" x 6-5/8".
This has one large and one small pocket (2 pockets total).