This 10-piece kit gives you 3 different methods of drilling in tight spots. Each shank is 1/4” x 28 which will thread into most drill spindles that angle attachments and angle drills are supplied with. 0.25 lb.
• (4) #200 collets & adapters - drill sizes 11, 21, 30, & 40
• (4) threaded drill bits (1-1/4” length) - drill sizes: 10,21,30,40
• (1) Cone jaw chuck Model TP258 .
WARNING: The product may contain and/or expose you to a chemical(s) or substance(s) which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. www.P65Warnings.ca.gov
Complete package of everything you need.
ANG DRILL COLLET & CHUCK KIT
Collets allow choice of drill bit length in the specific sizes. Item was shipped and arrived without delay. Recommended.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
We are not familiar with that drill but this kit is threaded 1/4-28.